1-3/4" OD Exhaust Header Fabrication System
$1,439.99
$1,469.98
(You save
$29.99
)
(No reviews yet)
Write a Review
1-3/4" OD Exhaust Header Fabrication System
This complete exhaust header fabrication system will take you from design to finished custom exhaust headers. The blocks snap together to model header primaries. Included with each block kit are both straight and curved blocks, which represent 1-inch arc length of tubing. Each block features arrows to aid with orientation, helping to plan as few cuts as possible. Blocks snap together and apart easily, allowing you to test a range of design iterations and make adjustments as issues arise. This Full System kit includes enough blocks to model both sides of a V8 engine. All EH Series blocks are compatible and can be connected to simulate stepped headers. Next, the cutting jig and cut spacers will allow for cutting of pre-bent U- and J-bends with 2, 3, 4, and 6-inch centerline radii. This will allow you to cut a metal replica of the plastic block sections that comprise your exhaust system without measuring any angles. Use with an upright bandsaw for quick and accurate cuts. Finally, the included clamps enable welders to preview and adjust pieces before tack-welding them, resulting in more precise assembly. Once tack-welded, the clamps can be removed, and the joint can be properly welded together.
Includes:
- (60) Straight blocks, 1750-00
- (60) 2 inch radius blocks, 1750-20
- (60) 3 inch radius blocks, 1750-30
- (60) 4 inch radius blocks, 1750-40
- (60) 6 inch radius blocks, 1750-60
- (8) Block adapters, 1750EHBA
- EHSeries radial cutting plate, PIV1000
- Cutting spacers for 2, 3, 4, and 6 inch CLR
- 4 piece tack-welding clamp kit, 1750EHTTWCS
- Manual
- Control sheet pad
- Plastic case
Related Products
-
-
-
-
-
-
-
-
-
-
1-3/4" OD 5-to-1 Collector Dummy
$135.00 -
